How To Attach Crown Molding

April 12, 2022

First do a dry fit to make sure that it fits perfectly and lines up in the corners. Old houses are notorious for having uneven ceilings.

How To Install Crown Molding Hgtv

How to Install The Crown Molding Once your crown molding is cut there are just a few steps to install it.

How to attach crown molding. Use 8 and 10 penny finish nails to secure the crown molding. Draw a faint line where the bottom of the crown moulding will lay. Pendant light sconce drawer pulls cabinet latch faucet paneling flat crown paint color the shadow line.

The width of the backer board is approximately 18. Use the caulk gun to cover up any gaps in the joint make sure youre using paintable caulk. Use a level or laser level to extend this mark along the walls from corner to corner Image 2.

When you are ready use a nail gun to nail the molding in place at the top and bottom of the moldings. Cut the Molding Swivel the saw to a 45-degree angle to match the direction of the molding set the board against the saw at the mark and make the cut. And that can make installing crown molding super frustrating.

Enter the shadow lineHolding the crown down below the ceiling a bit around 12 allows you to. This will help you keep the moulding straight. Use a stud finder to locate the studs.

This allows for the crown molding to be sucked tight to the wall and ceiling connections. Nothing is perfectly level and nothing is perfectly square. Hold crown molding inside out and backward to ensure it presses up safe against the miter saw.

Make faint pencil marks high on the wall to guide you as you nail. Attach it to the wall. How to Install Crown Molding.

Attach Crown Molding Dry fit the crown molding by holding the front piece and a side piece against the front and side of the baseboard Image 1. Write your measurement down to use when cutting your crown moulding. Make sure that it is precisely positioned.

For a long piece youll need some help holding it. If you need to join two pieces of molding along a wall use a butt joint not a scarf joint. With the nailing gun drive several nails through the lower edge of the crown molding and into the nailing strip.

If you choose not to use them note that the installation of plastic molding differs from that of wood molding. Before installing crown molding test fit a piece of molding in place Image 1 and mark the height of the molding where it meets the wall below the ceiling. Once the fit is right take the molding to the wall.

Now turn the miter saw to precisely 45 degrees and cut the crown molding. You can use polyurethane glue and small wood pieces on the base of the miter saw to keep the crown from slipping. Make sure the cleat is approx 18 to 316 smaller than the hollow behind the crown and NOT touching.

By Video Journalist Luis DiazWebsite. Attach the Crown Molding Front Section Hold the molding front section against the front nailing strip. A simple method to attach crown molding is to install a plywood backer board to the top plate which is the horizontal frame above the wall studs.

Measure the wall from corner to corner. Use a pin nailer to nail into the corners of the two pieces of crown molding Image 2. Push the end into the corner making the fit as tight as possible.

Make sure the pieces are together and in place snugly. Youll also want to nail the crown moulding into a stud for a secure hang.

Foam Crown Molding Installation And Product Review