How To Install Asphalt Shingles

January 25, 2021

Ask This Old House general contractor Tom Silva reveals the best ways to secure shingles to a roof. Asphalt Roof Shingles Installation - YouTube.

How To Install Asphalt Shingles 15 Steps With Pictures

Installing a new roof is a big investment so you need to be prepared to ensure the process runs smoothly.

How to install asphalt shingles. Once this is done you can now proceed with applying asphalt cement around the edges of the roof. Begin installing your atlas asphalt shingles. You want your seams to line up towards the bottom of the edge of the roof.

Get Results from 6 Engines at Once. Read on to learn about the steps to take before your asphalt shingles installation. 85 - On the wall cover the step flashing with an adhesive waterproofing membrane.

Get Results from 6 Engines at Once. Start with a full shingle and then overlap the roof by ½ an inch. Using the chalk line snap a line between the two marks to get a straight edge.

See below for a shopping list tools and stepsSUBSCRI. Cut 6 inches from the first shingle placed in the extreme left corner. Then you can put your nails right above the seal.

You want to make sure you overlap at a minimum of a quarter inch up to 34 of an inch. Ad Search Installation Of Roof. Make sure this row has a slight overhang 14 to 38 in beyond the drip edge.

86 - Install an air-barrier on the wall. Ad Search Installation Of Roof. To start installing shingles line up aluminum drip edge flush with the edge of the roof and make a pencil line at the top on each end of the house.

To align asphalt shingles nail down a shingle with the correct overhang on each end of the eaves. Repeat this alignment every third or fourth course. Then line up the top edges of intervening shingles along the chalk line.

Pull the drip edge down about a half-inch from that line to create a gap between the drip edge and the fascia board. If its time to replace your asphalt shingles and you have never dealt with this process before you came to the right place. In installing roofing shingles make sure that every cut you have made earlier is in the exact place.

84 - Install step flashing when shingles are being cut and installed the length of the wall. For the first row of shingles called a starter course or strip you cut the tabs off three-tab shingles and apply them with the self-sealing adhesive strip facing up along the eave. Snap a chalk line along the top edges of the shingles.

Pre-bent 8 x 8 flashing must extend up the wall at a height of 4 cover 4 of the asphalt shingle and overlap. Now install the first row of the three tab shingles from the bottom-left corner of the roof. Once you put the shingle in their area make sure to attach them using a hammer and asphalt nails.

Overlap the roof by ½ an inch. Then start placing the next shingles along that length and at the lower edge of the roof.

Pro Tips For Installing Asphalt Roofing Shingles